toolbox
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
pic_controlled_stepper_motor [2009/02/28 02:44] jonmash |
pic_controlled_stepper_motor [2009/03/08 18:22] (current) jonmash |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== PIC Controlled Stepper motor ====== | ====== PIC Controlled Stepper motor ====== | ||
| - | Code to send data to the PIC | + | * [[Code to send desired position to the motor controller]] |
| - | <code> | + | |
| - | void setup() | + | |
| - | { | + | |
| - | pinMode(3, OUTPUT); // sets the digital pin as output | + | |
| - | } | + | |
| - | void loop() | ||
| - | { | ||
| - | digitalWrite(3, HIGH); | ||
| - | delayMicroseconds(2000); | ||
| - | digitalWrite(3, LOW); | ||
| - | delay(100); | ||
| - | | ||
| - | } | ||
| - | |||
| - | |||
| - | void setup() | ||
| - | { | ||
| - | pinMode(3, OUTPUT); // sets the digital pin as output | ||
| - | } | ||
| - | |||
| - | void loop() | ||
| - | { | ||
| - | digitalWrite(3, HIGH); | ||
| - | delayMicroseconds(2000); | ||
| - | digitalWrite(3, LOW); | ||
| - | delay(100); | ||
| - | | ||
| - | } | ||
| - | </code> | ||
Brought to you by: Liliane Barbour, Jonathan Mash and Mike Studli
With the support of: Dr. Hashtrudi-Zaad
